clean the surface

clean the surface with a damp cloth where the graphic is being applied to ensure good adhesion, the best surface for the graphic to adhere to is clean, dry and smooth. if your walls were freshly painted, wait 2 weeks so the paint has a chance to fully cure

plan your design

to ensure you have your graphics laid out properly on your wall before you apply them. tape them on the wall to get an idea of the layout. if the graphic is intricate cut the excess paper off to get a better feel

rub-a-dub

lay your design on a hard surface graphic side down and firmly squeegee over the entire surface with the loxii applicator tool. this will transfer your graphic onto the transfer tape, so apply as much pressure as needed

peel the paper

peel off the paper side of the graphic. some graphics may stick to the paper, if so, continue to rub-a-dub and remove the paper slowly. left behind will be the graphic and clear transfer tape which is ready to be applied to the wall

stick it

carefully rub the graphic on the wall with the loxii applicator tool. rub from top to bottom being careful not to create bubbles or fold

if bubbles cannot be removed use a pin to release the air and rub the area with the applicator tool

final peel!

slowly peel off the clear transfer paper reveiling the applied graphic. if the graphic begins to pull off with the transfer paper, simply roll back down an use applicator tool to further smooth graphic down